Self-Adjusting Hall Effect Gear Tooth Sensor IC CYGTS9801, Output: Single NPN Voltage, Power Supply: 4,5 V ~ 24 V DC
Back- Article-Nr: CYGTS9801
- Serial-Nr: CYGTS9801
- Request on this Article
- Data Sheet Download
- Data Sheet Download (German)
The CYGTS9801 is a sophisticated Hall Effect Gear Tooth IC featuring an on-chip 12-bit A/D Converter and logic that acts as a digital sample and hold circuit. A separate 6-bit D/A converter provides a fixed hysteresis. The sensor does not have a chopper delay. It uses a single Hall plate which is immune to rotary alignment problems. The bias magnet can be from 1000GS to 4000Gs. As the signal is sampled, the logic recognizes an increasing or decreasing flux density. The output will turn on BOP after the magnetic flux has reached its peak and decreased by an amount equal to the hysteresis. Similarly the output will turn off (BRP) after the flux has reached its minimum value and increased by an amount equal to the hysteresis.
Characteristics
- High sensitivity
- Digital output signal
- Zero speed detection
- Short circuit protection
- Insensitive to orientation
- Wide voltage working range
- Self-adjusting magnetic range
- On-chip 12 bit A/D converter
- High speed operation
- No chopper delay applications
- RoHS compliant
Applications
Automotive and Heavy Duty Vehicles:
- Camshaft and crankshaft speed and position
- Transmission speed
- Tachometers
- Anti-skid/traction control
Industrial Areas:
- Sprocket speed
- Chain link conveyor speed/distance
- Stop motion detector
- High speed low cost proximity
- Tachometers, counters
Operating Temperature: | -40°C~ +150°C |
Power Supply: | 4.5V ~ 24V DC |
Output Signal: | Single NPN Voltage |
Rise/Fall time: | 0.4µs/0.4µs |
Package/Size: | SIP3/4.0x3.0x1.5mm |
Sensing gap/distance: | 1.0mm ~ 3.0mm |
Bias Magnetic Field: | 100~400mT |